1. Test the previous touch switch circuit, make some finely condition.
2. Prepare the devices to build up another switch circuit.
3. Add touch switch circuit in simulation then test it.
4/13
Test the previous circuit.
4/14
Taking some classes.
4/15
Search datasheet about other types of switching transistor to replace the lack one.
4/16
Test several other FET transistor for this circuit, but found that … Continue Reading ››
1. Finish modify the circuit when compare with the simulation
2. finish the comparater part of the circuit
1/26
Change the capacitor in three different sizes to choose the most match one.
1/27
Set the new rectification circuit and observe the voltage form
1/28
Make two different conditions of voltage comparater in software
1/29
Finish testing the comparater and choose the more stable one
1/30
Add … Continue Reading ››
1. Finish revise the paper
2. improve the touch switch circuit
1/19
Modify the paper for the conference.
1/20
Design voltage comparator on softwareContinue Reading ››
1. Prepare the representation of Thursday.
2. Test the internal voltage amplifier on the soft ware.
12/15
Nothing about the study.
12/16
Prepare the PPT.
12/17
Test the voltage amplifier on the example circuit.
Report the research process to teacher Yang.
12/18
Improve the material about the presentation.
12/19
1. Get familiar with the AMP in user module
2. Build up a physical circuit about AMP on the broad.
12/08
Study the document about the AMP and PWM8 in user module.
12/09
Nothing
12/10
Modify the papers and report the progress to teacher Yang.
12/11
Study the Amplifier user mode with reading the document about the introduction.
12/12
Design a waveform which can output the set … Continue Reading ››
1. Finish calculate the output of the detection circuit
2. Build a physical circuit by using the PSoc
12/01
1.simulate the circuit and analysis the waveform.
2. have some problem in calculate the output of the detective circuit.
12/02
Refer to the relevant information on the calculation of the amplifier
12/03
Report to Teacher Yang about the progress of research.
Prepare the information about … Continue Reading ››
1.Build hardware circuit to test the circuit
2. build the touch control switch circuit with PSoc
11/25
Download the program into a chip
11/26
Test the chip and there are some problems to complete the function.
1. Changing the different resistances to compare the output of the whole circuit.
2. Learning how to use PSOC to program a simple circuit.
11/17
set other groups of the resistances and compare the differences.
11/18
Reading the PSoc user guiding paper and operate it in the software.
11/19
Trying a small example in the software and still don't finished program it.
11/20
Finish programming and reading … Continue Reading ››
目標：
1.Learn to use PSoC software
2. Get familiar with the touch control circuit
11/10
Install the Software on the computer and start to create a new project!
11/11
Draw a circuit in PSpice and get some error about the simulation of the circuit.
Analysis part of the circuit and understand the function of component in this part.
11/12
Solve the circuit problem in using the … Continue Reading ››
